Today we talk about how to run a thread. We will cover then the radial increment, the parallel one and also the alternated one.
The 3 ways.
RADIAL INCREMENT
- the primary and secondary sharps are both employed in equal measure
- the length to which the cut is high
- it is possible the occurrence of harmful vibrations for surface finish.
PARALLEL INCREMENT ALONGSIDE THE THREAD
- the secondary sharp is used on a smaller measure (equal to the same increase)
- there is a better chip formation and control
there are increments to ensure a constant chip section
ALTERNATED INCREMENT
- it is used for large diameter threads
- there is an undifferentiated wear between the two sharps and there is also an increased tool life
Threading lathe tool.
In this practice is carried out a drain throat (unified form) in order to avoid the formation of an incomplete end thread.
What are the advanteges?
- It ensure the tool the ability to disengage
- It allows you to install screw up:
– against the shoulder
– at the bottom of a hole
- it prevents the formation of burrs in the incomplete thread
Threading tools.
What are the thread cutting tools made? Generally of:
- High speed steel (the use is limited by the low volume of metal removal rate over time)
- Sintered hard metal
What are the tools that are used to make threads on a lathe? They are tools with insert. Thanks to these:
- The whole profile is produced (including the upper end of thread)
- Its deletes the final finish of the crest of thread
The type of inserts.
INSERTS WITH V-PROFILE
- they are commonly used
- they don’t work the thread crests
INSERTS A COMPLETE PROFILE
- You can make the entire shape of the threaded profile
DOUBLE PROFILE INSERTS
- The second tooth penetrates deeper into the machined surface
Find our webshop.
Click on the link below to access on our web shop. You can choose the most suitable items to your customers needs.
